The most important debugging tool in any toolbox is a trusty multimeter. A multimeter can measure continuity, resistance, voltage and sometimes even current, capacitance, temperature, etc.
These instructions are in two separate videos:
This is a photo montage made by Anna Sea of her installing an e23M-3 kiln. It gives you a good visual idea of the steps involved.
Installation instructions for L&L's Vent-Sure Downdraft Kiln Vent.
Vent-Sure Vent System All Vent PartsThis video shows how to drill your kiln bottom for a Vent-Sure ventilation system in case you are installing on a new kiln or if your holes are not already predrilled. The number and sizes of holes can be determined by looking in the vent instructions.
The Vent Control allows you to automatically control the operation of the Vent-Sure kiln vent with one of the outputs from the DynaTrol (or Genesis).
From Jessica Putnam-Philips:
Yes, you can install a kiln vent. If I can do it you can do it! In this video, I walk you through all the steps to safely install the kiln vent.
This video shows you how to properly adjust your spring hinge. Proper adjustment can prevent damage to your kiln and ensure that the lid closes properly.
Installation instructions for L&L's new reengineered spring hinge system.
PartsHow to retrofit your kiln with L&L's new hinge technology.
PartsThis video shows you how to adjust the spring tension on your spring hinge in case the lid is too heavy or too light.
