Use the Supplied Kiln Stand
All Cautions
SAFETY NOTICE
INSTALLATION CAUTIONS
- Use A Qualified Electrician
- Clearances and Flammable Surfaces
- Check Temperatures Around Kiln
- Leveling the Kiln
- Adjusting the Hinge Properly
- Thermocouples
- Use the Supplied Kiln Stand
- Don't Use an Extension Cord
- Power Cord Must Be Properly Rated
- Use Copper Wire for Hook Up
- Protect Power Cord From Kiln Case
- Keep Kiln Dry & In Protected Space
- Keep A Fire Extinguisher Near Kiln
- Sprinkler Cautions
GENERAL ENVIRONMENT CAUTIONS
PREFIRING CAUTIONS
LOADING & UNLOADING CAUTIONS
- Turn Off Power While Loading
- Keep Lid Closed When Kiln Is Not In Use
- Do Not Store Anything On Lid
- Do Not Open The Door Above 250°F
- Do Not Unload Kiln While Hot
- Be Careful of Sharp Objects
- Secure Lid While Loading or Unloading If You Have A Spring-Loaded Easy-Lift Hinge
- If You Have a Davinci Counterbalanced Lid
- If You Have A Basic Hinge With Chain Supports
- Viewing Into The Kiln
FIRING CAUTIONS
- Attend The Firing
- Make Sure Your Kiln Sitter Is Adjusted
- Use Kiln Wash On The Cone Supports
- Understand Your Control
- Program Review on Automatic Kilns with DynaTrol Controls
- Do Not Confuse Cone Numbers
- Use The Proper Thermocouple
- Check Thermocouple Calibration
- Shut Off Kiln At Disconnect or Circuit Breaker
- Do Not Fire Kiln Above 2350°F (1290°C, Cone 10)
POST FIRING CAUTIONS
GENERAL MAINTENANCE CAUTIONS
KILN MODIFICATIONS CAUTIONS
- Do not use kiln without the supplied stand.
- Never set a kiln on a floor without significant air space circulating under the kiln.
- L&L stands typically raise the floor of the kiln by 8" (20 cm).
