Technical Support

Thumbnail: 

How to check to see if the internal switches on a DynaTrol board are operating properly.

Thumbnail: 

How to check a relay in an Easy-Fire Kilns

1. Similar in any L&L automatic kiln.
2. Follow proper electrical safety practices.

Thumbnail: 

How to enter a cone offset into a DynaTrol.

Thumbnail: 

How to turn off the error codes on a DynaTrol.

For more detail see this.

Thumbnail: 

How to change from Degrees F to C on a DynaTrol control.

Thumbnail: 

How to change the thermocouple offset on a DynaTrol. This helps you calibrate the control to match your kiln.

Thumbnail: 

How to change a DynaTrol from a three or two zone control to a single zone.

Thumbnail: 

This video shows how to check a control fuse on an L&L automatic kiln.

Thumbnail: 

How to change a control fuse holder in an Easy-Fire Kiln

1. Similar in all L&L kilns with automatic controls.
2. Make sure kiln is unplugged or locked out and tagged out at the c
   

Thumbnail: 

1. Loosen the case.
2. Remove elements from holders.
3. Remove the damaged brick.
4. Insert new brick.
5. Tighten case.
6. Sand and patch.
7. Reinstall elements.