How to check to see if the internal switches on a DynaTrol board are operating properly.
This video shows you how to review a program on the DynaTrol program control on an L&L automatic kiln.
When in doubt it is almost always better to fire slower than faster.
A slower firing allows for more time for water vapor, fumes and gasses to escape from the body of the clay body.
Change of Program During Firing: When firing you can alter the program anytime. You must press START/STOP, then reprogram, then press “Start”.
A customer asks: I would like to program my kiln to heat to Cone 6 then cool normally to 950°F and then hold for one hour at 950°F and then cool naturally.
The type of thermocouple on a DynaTrol (with the Blue face) can be either Type K or Type S.
The ultimate in precision firing is achieved by using the DynaTrol to control the ramping of the kiln (both up and down) but using a witness cone and your eye to control when the firing stops.