Ensure Kiln Has Been Programmed Correctly

Home >

Click on image to enlarge

More Images

Ensure Kiln Has Been Programmed Correctly
  1. Make sure you have programmed the kiln properly and it is supposed to be firing.
  2. Read the Operation instructions.

Applicable Knowledgebase Articles

How to fix E- 2 or Err2
Why does my kiln jump over the Preheat without holding at the Preheat temp?
How to Program Easy-Fire Programs for DynaTrol
How do hold times and heatwork affect my work?
Why does my kiln seem like it underfires the pottery?
Why does my kiln seem like it overfires the pottery?
Why do I get TC-- code when I run my 3-button Bartlett
Does the digital controller have a way to prevent an over fire?
The center of my kiln gets too hot compared to the top and bottom.
What is the E- A code on the DynaTrol and how do you fix it?
What do I do if the display is normal but the kiln won't heat up?
What to do if the kiln fires slowly?

Cautions

Understand Your Control
Program Review on Automatic Kilns with DynaTrol Controls

Videos

Firing a Kiln with Witness Cones (Video)
Programming your L&L Easy-Fire kiln for your first test firing (Video)
Recalling a Vary Fire Program on the DynaTrol on an L&L Kiln (Video)
Setting OTHER options on the DynaTrol Control on an L&L kiln (Video)
Turning on the DynaTrol on an L&L Kiln (Video)

PDFs

Easy-Fire for Continental Europe & United Kingdom (7.74 MB)
Easy-Fire Instructions in German (174.70 KB)
First Firing Instructions for L&L Kilns with a DynaTrol (143.05 KB)
Fuego & Robin for Continental Europe (2.39 MB)
Fuego & Robin for United Kingdom (2.51 MB)
Operation Instructions for the Liberty-Belle using the 3-Button Control (130.37 KB)
3-Button Bartlett Control Instructions (115.28 KB)
DynaTrol Instruction Manual (Blue Face 4.2 - 4/03 to 12/05) (501.45 KB)
DynaTrol Instruction Manual (Green Face 3.2 - before 4/03) (396.50 KB)
DynaTrol Control Instructions (Blue Face 5.0 Current from 1/06) (1.00 MB)